Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit, but it still feels attractive. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can aid whether the issue is constant or intermittent.
Water Damage
If you happen to leave your key fob in a puddle or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it's more likely to sustain water damage. Keep your key fob in a dry bag whenever you go outdoors or do activities that expose it to excessive water.
You'll also need to make sure that the fob is completely dry prior to opening it and re-using it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's been submerged.
A wet circuit may cause the battery's power to be depleted or even explode. If you are able to get your keyfob 308 from the water you need to turn the button side up and shake as much water out as you can before opening the casing. Remove the battery, then wipe the circuit board down with a cotton swab, which has been dipped in 90-percent alcohol.
Other reasons your Peugeot 308 remote keyless entry system could be unable to function could be due to an empty coin battery or receiver module issues signal interference, a faulty electronic chip. If none of the above is the issue, you can reset the system by disconnecting a 12 voltage battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars come with a remote start system that lets drivers start their car from the distance, allowing them to warm up or cool down the car before entering. This feature is extremely helpful particularly during the cold winter months. However, it is possible that the remote start system ceases working due to a variety of causes, such as the battery of a coin that is dead.
A coin-shaped battery that is in the key fob has a lifespan of between two and four years, based on how frequently it is used and where it's purchased. The date of use will be displayed on the packaging or in the user's manual.
If the key fob has stopped working after exposure to water that is clean, remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If G28 Car Keys expose it to soapy or salty water, the chip might be damaged and you'll require replacing the key fob in total.
If you're unsure whether the battery is defective it is possible to check its voltage using a multimeter that is connected to both the minus and plus terminals. The voltage should be around 12-13 volts but if it's lower, then the battery needs to be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should be able to start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, it's possible the receiver module has been afflicted with a fault. It's the part that transmits an alert to the car when your key fob is activated, which also acts as an immobiliser, and stops it from starting until the correct key is present.
This could be due to a range of causes, such as water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob has been damaged by dirty tap water It could be because the keyfob was exposed it. In this instance, you'll need to take off the battery and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once the battery is dry, you can try again.
If the issue is not resolved, it is recommended to consult a local Peugeot expert or locksmith. They'll be able make use of a diagnostic device to help pinpoint the issue and fix it.
It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can solve the issue in just a few minutes. They can program your vehicle and cut a fresh, working key for you. Click here to find a locksmith near you.
Faulty electronic chip
The electronic chip in the Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you could encounter issues starting your car or receive a message stating "anti-theft". If this happens, the only way to fix the issue is to replace the key. Luckily, auto locksmiths who are professionals can complete the task within the shortest period of time.
The chip inside your Peugeot 308's key fob could be damaged due to various reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must clean it right away. You can make use of a towel and isopropyl ethanol to clean the electronic component. Then, you need to allow the battery to dry completely.
Radio interference can cause the key fob to stop working. This can happen when other devices use the same frequency as your Peugeot keyfob. This could be due to unsafe conditions or objects that are within the vicinity of the vehicle. If you experience this issue it is advised to visit an Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and requires special attention. You shouldn't drop it or throw it around. If you lose it, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Make sure you disconnect the negative first, and then the positive.